Home  |  Forums  |  914 Info  |  Blogs
 
914World.com - The fastest growing online 914 community!
 
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG. This site is not affiliated with Porsche in any way.
Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners.
 

Welcome Guest ( Log In | Register )

> Anyone have an opinion on ITB size for a 2.0, Working on a ITB for our 912
rick 918-S
post Nov 19 2026, 09:23 PM
Post #1


Hey nice rack! -Celette
***************

Group: Members
Posts: 21,388
Joined: 30-December 02
From: Now in Superior WI
Member No.: 43
Region Association: Northstar Region



I have a stock 2.0 with Euro pistons and a lightened flywheel Other than that, Stock FI cam. No other changes. I ordered some 40MM ITB's but then realized my intakes are for 48-50 MM Carbs. Any think I could run 48-50 MM ITB's on a stock high compression 2.0?
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
 
Reply to this topicStart new topic
Replies
GregAmy
post Nov 20 2026, 07:42 AM
Post #2


Advanced Member
****

Group: Members
Posts: 2,722
Joined: 22-February 13
From: Middletown CT
Member No.: 15,565
Region Association: North East States



My opinion? With stock 2L D-Jet cam and more compression 40mm would possibly be a bit big; I'd think more 36 or smaller.

For reference, my street car setup is Microquirt with the stock D-Jet induction (plenum, tubes, throttle body) and the engine is 2056 with a FAT EFI cam (.398 lift/252 duration) and another point of compression. Looking through the logs it appears that the manifold pressure is rarely hurting for air until I get above 6000RPM, which is kinda rare for street driving.*

The 2056/9.5:1 race engine, 6500RPM redline with Web C cams is running Dells with 38mm chokes and is constantly tempting me toward over-revving. But it does not like driving around at 2k.

But with modern EFI any reduction in drivability at low RPM is something you can likely tune around with Microsquirt.

Let us know how it works out!

*My tilt for a street car is always too small vs too large, primarily for drivability preference; I'd rather have a good-driving car down low versus one that revs out. It's exactly opposite in the race car: gimme revs I don't care what happens down low.

So take that bias with your grain of salt.
User is offlineProfile CardPM
Go to the top of the page
+Quote Post

Posts in this topic


Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



- Lo-Fi Version Time is now: 21st November 2026 - 01:18 AM
...