|
|

|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| rick 918-S |
Nov 19 2026, 09:23 PM
Post
#1
|
|
Hey nice rack! -Celette ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() Group: Members Posts: 21,388 Joined: 30-December 02 From: Now in Superior WI Member No.: 43 Region Association: Northstar Region
|
I have a stock 2.0 with Euro pistons and a lightened flywheel Other than that, Stock FI cam. No other changes. I ordered some 40MM ITB's but then realized my intakes are for 48-50 MM Carbs. Any think I could run 48-50 MM ITB's on a stock high compression 2.0?
|
![]() ![]() |
| GregAmy |
Nov 20 2026, 07:42 AM
Post
#2
|
|
Advanced Member ![]() ![]() ![]() ![]() Group: Members Posts: 2,722 Joined: 22-February 13 From: Middletown CT Member No.: 15,565 Region Association: North East States
|
My opinion? With stock 2L D-Jet cam and more compression 40mm would possibly be a bit big; I'd think more 36 or smaller.
For reference, my street car setup is Microquirt with the stock D-Jet induction (plenum, tubes, throttle body) and the engine is 2056 with a FAT EFI cam (.398 lift/252 duration) and another point of compression. Looking through the logs it appears that the manifold pressure is rarely hurting for air until I get above 6000RPM, which is kinda rare for street driving.* The 2056/9.5:1 race engine, 6500RPM redline with Web C cams is running Dells with 38mm chokes and is constantly tempting me toward over-revving. But it does not like driving around at 2k. But with modern EFI any reduction in drivability at low RPM is something you can likely tune around with Microsquirt. Let us know how it works out! *My tilt for a street car is always too small vs too large, primarily for drivability preference; I'd rather have a good-driving car down low versus one that revs out. It's exactly opposite in the race car: gimme revs I don't care what happens down low. So take that bias with your grain of salt. |
| Superhawk996 |
Nov 20 2026, 08:51 AM
Post
#3
|
|
914 Guru ![]() ![]() ![]() ![]() ![]() Group: Members Posts: 8,184 Joined: 25-August 18 From: Woods of N. Idaho Member No.: 22,428 Region Association: Galt's Gulch
|
*My tilt for a street car is always too small vs too large, primarily for drivability preference; I'd rather have a good-driving car down low versus one that revs out. It's exactly opposite in the race car: gimme revs I don't care what happens down low. So take that bias with your grain of salt. That’s not a bias - that’s solid engineering. There is a reason the 2.0L - 2.4l /6 engines used 27-28mm Venturis - drivability. It wasn’t because a Porsche didn’t know how to tune or how to make more horsepower at the top end. With ITB’s you’re probably going to end up running Alpha-N tuning. Large ITBs are going to exacerbate the problems ITB’s have with off idle transition. It’s the same thing as running a set of Weber IDF 44’s or 48’s on a 2.0L engine, sure you can choke them down with small Venturis but due to the non-linear air flow as the throttles begin to open just off idle, they get boggy & jerky. The larger the throttle plates, the more of a problem the off-idle transition becomes. Whether your tuning carbs or FI the underlying principles of managing air flow and velocity are the same. If your air velocity in the intake falls off at off-idle transitions then picks up rapidly as the engine gains RPM, you can tune tune the fuel but you’ll still feel the bog off idle as air velocity dies momentarily. Big manifolds and ITBs that are too large just make it all worse and that off idle transition is the weak spot of ITB’s. Why make that weakness of ITB’s and Alpha-N tuning even worse? Honestly - consider selling what you have and downsize. For what it’s worth - go read reviews of sport bikes like the Ducati 996 or Honda CBR 600 F4 around 1999 - early 2000s when they were all transitioning to Fuel Injection and see how many had bad throttle response issues at low speed and Low RPMs. Then ask yourself if you think you are going to be better at tuning or have more resources at your disposal than Ducati, Honda, etc. |
rick 918-S Anyone have an opinion on ITB size for a 2.0 Nov 19 2026, 09:23 PM
sixnotfour This guy been doing em longer than most.. Have see... Nov 19 2026, 11:00 PM
rick 918-S Thanks. I have everything with the except I messed... Nov 20 2026, 04:39 AM
VaccaRabite :agree:
If you think about carbs they are necked d... Nov 20 2026, 08:21 AM
JamesM
I have a stock 2.0 with Euro pistons and a lighte... Nov 20 2026, 09:23 AM
JamesM As a side note, I designed and build the EFI syste... Nov 20 2026, 10:25 AM![]() ![]() |
|
Lo-Fi Version | Time is now: 21st November 2026 - 01:18 AM |
| All rights reserved 914World.com © since 2002 |
|
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |