injector elbows, where to cut to remove crimp? Options

[joeav8tor]

hi guys,
I am dropping my engine this weekend and doing some preventative maintenance and tune up...I got a set of injector elbows with the hose clamps...does someone have a picture of where I cut to get the crimp off, to install the new elbows...and any other tips..thanks
Joe (IMG:http://www.914world.com/bbs2/html/emoticons/flag.gif)

[dmenche914]

To remove the factory crimp clamps on the fuel hoses:

The factory clamps are crimped onto the hoses for the injector. You need to cut them to remove them. The injector has a barbed fitting to accept the new hose, use a fuel injection rated hose clamp (ie not the ones with the serrated 'teeth) The correct replacement clamps have a solid band of metal in contact with the hose, and will not tear the hose nor lossen.

To remove the factory climped clamp, put the injector in a vice (on metal surfaces only, the plastic is brittle, and can crack, causing leaks)

I have used a hacksaw and / or a tin snips to cut away at the crimp clamp. Just cut the clamp down to its base, and then around it. You then should be able to pull off the old hose, and remaining bits of the factory clamp with no problems.

Good luck