Pressure plate / flywheel, Can they both be resurfaced? Options

[ammason]

So I'm swapping the clutch and have found that my pressure plate is toast and my flywheel has three broken teeth. I have another pressure plate and flywheel that have only spent about an hour on the road in a car from Santa Cruz, the only problem is that the hour was in 2003 and the car was totaled and left in the elements. The clutch disc rusted to the flywheel and pressure plate, pitting both of them nicely.

I was told that the flywheel can't be resurfaced because it's been resurfaced before, so I may have to spring for a new (to me) one, but the pressure plate is in great shape, save for the pitting on the friction surface. Do you guys know if pressure plates can be resurfaced? Anyone know a good shop in the bay area to do this and to check my other flywheel to see if I can get it turned down again?

Anyone got a good flywheel for cheap? I have a buncha parts to trade off the '72 incuding a complete non-running, leaf-covered 1.7L engine...

[davep]

The flywheel can be resurfaced until the friction disk hits the bolt heads, so an expert has to determine the possibility. The PP mounting surface has to be machined down as well so that the height difference btween the friction surface and the PP mount surface remains constant. Theoretically, you could surface the PP and remove more from the flywheel. Basically the gap for the friction disk must be at the factory spec. Then the ball for the throwout fork must be move out an equivalent amount. Hard to say if that was done correctly previously, and with a different flywheel you would have to figure it out anyway. A tricky business to do correctly.