 Suspension Bushing Lube, What to use? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Lawrence |
 Jun 28 2003, 08:57 AM
Post
#1
|
|
Senior Member  Group: Benefactors Posts: 1,661 Joined: 5-February 03 Member No.: 244 Region Association: None   |
I'm going to start reassembling the front of my car. What lube should I use on these bushings??
They are StrasseUSA units. JP said that he used silicon based grease? -Rusty |
   |
 
|
  |
Replies
| Lawrence |
Jun 28 2003, 05:17 PM
Post
#2
|
|
Senior Member Group: Benefactors Posts: 1,661 Joined: 5-February 03 Member No.: 244 Region Association: None |
Okay. I'll pick up some of that silicone grease. It's less than two bucks at Home Cheapo.
No, but I'll do the grooves tonight after my son goes to bed. It's his birthday, today. 7 years old. How wide/deep should the grooves be? |
|
|
|
Posts in this topic
Lawrence914-6 Suspension Bushing Lube Jun 28 2003, 08:57 AM
Drums66 That sounds good! silicone saves the rubber, I... Jun 28 2003, 11:03 AM campbellcj IIRC my t-bars (or was it the bushings?) came with... Jun 28 2003, 11:16 AM Jeff Krieger Lawrence, what kind of bushings are those? I went ... Jun 28 2003, 11:32 AM Lawrence914-6 They are 911 bushings. The bushings should be the... Jun 28 2003, 12:36 PM MarkV I have seen some grease that may be what you are l... Jun 28 2003, 01:16 PM MarkV Says it's good for 450 degrees & won't was... Jun 28 2003, 01:22 PM J P Stein Rusry: Those are the same bushings that I got from... Jun 28 2003, 02:53 PM Bleyseng Yep, its a silicon grease atleast the stuff JP for... Jun 28 2003, 02:56 PM Bleyseng Mike Mueller posted that picture of the dremel too... Jun 28 2003, 06:31 PM Lawrence914-6 3/16 deep?
that's a joke, right? The front b... Jun 28 2003, 06:44 PM Jeff Bowlsby Silicone attacks and degrades rubber gentlemen. f... Jun 29 2003, 08:49 AM Lawrence914-6 Jeff, thanks for the tip.
I found a good brake as... Jun 29 2003, 09:02 AM Bleyseng I didn't have one in my hand to measure but ok... Jun 29 2003, 12:44 PM
Gint Found this old rennlist post and an answer from
... Jun 29 2003, 08:18 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 16th July 2025 - 03:38 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.