 "Rust"oration, material? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| 14Maschine |
 Jun 6 2005, 06:10 PM
Post
#1
|
|
Newbie  Group: Members Posts: 48 Joined: 18-November 04 From: Pleasanton, CA Member No.: 3,137  |
My floor boards got some rust. Infact one of me seat brackets came right off. So I pulled out the seats. No structural damage yet. It looks minimal to what ive seen. Mabey I caught it early enough. I will get to the point now
I may not need an entire floow pan and if I dont have to pay 115 bux for one I wont! What steel could I replace the floors with? Perhaps I only need to replace small sections. Cold rolled mild steel? What gauge thickness? I intend on using Mig welder. I got some Naval Jelly. Couldnt find POR 15 at the hardware store. Sugestions, comments, welcome! |
   |
 
|
Posts in this topic
Verruckt If you only see a "little bit" of rust, get yourse... Jun 6 2005, 06:20 PM
lapuwali POR-15 has to be ordered from them, although a few... Jun 6 2005, 06:21 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 12th July 2025 - 10:29 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.