 ground strap, could this be why it's not starting? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| vmills |
 Jun 7 2005, 10:55 PM
Post
#1
|
|
Newbie  Group: Members Posts: 39 Joined: 5-May 05 From: Andover, MA\Watertown, WI Member No.: 4,033  |
I was wondering if there's a ground strap on the transmission or engine. I get spark when I pull a plug wire and put a plug on and ground it, and I'm 95% there's fuel and compression, so I'm wondering if it's not sparking when I put the plug wire back on the plug that's in the engine.
Pictures, help, anything is appreciated thanks vic |
   |
 
|
  |
Replies
| Rand |
Jun 8 2005, 01:12 AM
Post
#2
|
|
Cross Member Group: Members Posts: 7,414 Joined: 8-February 05 From: OR Member No.: 3,573 Region Association: None |
If it cranks strong, I wouldn't think the ground strap is the problem. Usually if a ground strap connection is bad enough to cause a problem with the car running, the symptom would be it doesn't crank (or cranks slow, or hesitates before cranking). But I digress. For certain, it's important to make sure the ground strap is clean and tight.
|
|
|
|
Posts in this topic
vmills ground strap Jun 7 2005, 10:55 PM
Bleyseng The ground strap goes from the nose cone bolts to ... Jun 7 2005, 10:58 PM vmills nose cone bolts? Where are those? Jun 7 2005, 11:00 PM Bruce Allert Go under the car from the rear and look up on the ... Jun 7 2005, 11:13 PM vmills Thanks, greatly appreciated.
I'll look at it t... Jun 7 2005, 11:14 PM SirAndy Jun 7 2005, 11:14 PM Joe Sharp The bolts that hold the part of the tranny that ha... Jun 7 2005, 11:15 PM ThinAir914 Here is a picture of the ground strap. There is a... Jun 7 2005, 11:28 PM Andyrew If for some reason you dont have a ground strap. I... Jun 7 2005, 11:56 PM ThinAir914 Jun 8 2005, 12:05 AM xsboost90 yeah mine wouldnt crank right, i ran a ground fro... Jun 8 2005, 05:56 AM vmills Hmmm...
Our engine cranks fine, and we used one of... Jun 8 2005, 10:23 AM vmills I have another question quick which might help me ... Jun 8 2005, 10:35 AM Bruce Allert Are you asking in what sequence?
Looking at the d... Jun 8 2005, 11:12 AM Mueller Jun 8 2005, 11:15 AM vmills I actually looked in haynes - couldn't find it... Jun 8 2005, 11:48 AM
MarkG A popular modification with the 'other Axis... Jun 8 2005, 12:48 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 2nd April 2026 - 10:04 AM |
Invision Power Board
v9.1.4 © 2026 IPS, Inc.