 Head cc's |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Dave Bell |
 Nov 14 2005, 01:21 AM
Post
#1
|
|
Member  Group: Members Posts: 234 Joined: 27-November 03 From: Santa Clarita, CA Member No.: 1,398 Region Association: None  |
Anybody know where you can find the head volume, cc's, for the different 914 stock heads?
1.7L 1.8L 2.0L - Dave |
   |
 
|
  |
Replies
| davep |
Nov 14 2005, 09:46 AM
Post
#2
|
|
914 Historian Group: Benefactors Posts: 5,262 Joined: 13-October 03 From: Burford, ON, N0E 1A0 Member No.: 1,244 Region Association: Canada  |
Are the heads all the same for all the various VW designs; that is, are all 1.7 heads the same? For the different compression ratios, say on the 1.7 engine, were the variations accomplished with different dishes in the pistons? I'm referring to all variations regarding the VW type 4 engine, not just the 914 variants.
|
|
|
|
Posts in this topic
Dave Bell Head cc's Nov 14 2005, 01:21 AM
MattR Its going to vary from engine to engine. If you... Nov 14 2005, 03:36 AM SpecialK ....or just use a graduated syringe (bigger the be... Nov 14 2005, 04:50 AM Jake Raby Measure the heads!!! You never know if... Nov 14 2005, 09:38 AM Bleyseng The heads have different combustion chamber shapes... Nov 14 2005, 10:20 AM Dave Bell O.K. ... measure them
I have two sets of 1.8 head... Nov 14 2005, 01:16 PM nebreitling i wouldn't dremel out the heads unless i reall... Nov 14 2005, 02:20 PM MattR Do NOT dremel the heads. They are shaped that way... Nov 14 2005, 02:24 PM Dave Bell I don't have the pistons yet, but you guessed ... Nov 14 2005, 04:03 PM Mark Henry Unless you know someone with the proper boring jig... Nov 14 2005, 04:27 PM Mark Henry BTW....are you going to chance the cheap lifters..... Nov 14 2005, 04:36 PM Jake Raby Oh no...
I see someone heading down the wrong road... Nov 14 2005, 05:02 PM
Dave Bell O.K. Jake... I pm'ed you. Nov 14 2005, 06:30 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 9th May 2025 - 10:00 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.