push rods - cut to length, need intsruction |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
push rods - cut to length, need intsruction |
qa1142 |
Dec 10 2005, 04:05 PM
Post
#1
|
Whiplash Group: Members Posts: 1,514 Joined: 1-June 04 From: Lake Zurich, Illinois Member No.: 2,140 |
Ok so I searched and found a thead on rocker geometry (nice pdf too (IMG:http://www.914world.com/bbs2/html/emoticons/smilie_pokal.gif) )
So who can tell me (step by step) on how to cut Jake's rods to lenght (IMG:http://www.914world.com/bbs2/html/emoticons/av-943.gif) Sorry had to put it that way (IMG:http://www.914world.com/bbs2/html/emoticons/beerchug.gif) |
ChrisFoley |
Dec 11 2005, 08:44 AM
Post
#2
|
I am Tangerine Racing Group: Members Posts: 7,934 Joined: 29-January 03 From: Bolton, CT Member No.: 209 Region Association: None |
Once I have the correct length calculated I cut them off with a bandsaw about .02-.03" longer than the finished length. Then I finish cutting them in a lathe to the precise length plus or minus a few thousandths. To complete them place the end with the tip into an old lifter, standing on a workbench. Insert the second tip and drive it on with a dead blow hammer against a second lifter.
|
Lo-Fi Version | Time is now: 1st June 2024 - 06:57 AM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |