 L-jet issues, cold starting. |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| bd1308 |
 Jan 27 2006, 10:57 PM
Post
#1
|
|
Sir Post-a-lot  Group: Members Posts: 8,020 Joined: 24-January 05 From: Louisville,KY Member No.: 3,501  |
first start, i cant get it to run for more than 10 seconds...just coughs and dies. I think its my points going south, they're pretty pitted which looked wild. I'm either holding out for a good set of BOSCH points and condensor, or just going with Pertronix altogether. If someone has an extra one, could I borrow it and pay you back when I get my job?
Anywho, second start, I have to rev it to around 2500-3000 for 15 seconds, and then its okay. idles at 1600 or so until warm then idles at 1000. I can hear it missing a little, but again i think its from the points. FLAPS has the shittiest points set i have EVER seen. anybody have any hints or do you concur with my diagnosis? b |
   |
 
|
  |
Replies
| sean_v8_914 |
Jan 28 2006, 12:57 PM
Post
#2
|
|
Chingon 601 Group: Members Posts: 4,011 Joined: 1-February 05 From: San Diego Member No.: 3,541 |
Hey Rich, I live on your street...Towle Court
a really good mech once told me "check all teh cheap stuff first" I thought that pitted points meant a bad condenser. if you sand them like Rich said, it should run better for a while if that is the problem. if it degrades again then change teh condenser (capacitor on teh side of dizzy) |
|
|
|
Posts in this topic
bd1308 L-jet issues Jan 27 2006, 10:57 PM
sean_v8_914 IIRC Compufire gets more favorable reviews around ... Jan 28 2006, 12:03 AM bd1308 not at all http://www.914world.com/... Jan 28 2006, 07:34 AM r_towle Britt,
Do you have a dwell meter?
Get some emery ... Jan 28 2006, 08:49 AM r_towle Stop dripping oil on my street.
Rich Jan 28 2006, 04:20 PM bd1308 i hate the piece chinese crap I get from FLAPS.
i... Jan 28 2006, 11:14 PM Rand FWIW... Points are not THAT lame... They should no... Jan 28 2006, 11:22 PM bd1308 OK
you have a point.
I used a dremel to clean of... Jan 29 2006, 07:41 AM bd1308 popped in a new set of points (keeping same conden... Jan 29 2006, 01:36 PM r_towle ok,
Now from PP, you can get bosch point for a wop... Jan 29 2006, 04:22 PM
bd1308 okay same deal....
when is the cold start injecto... Jan 30 2006, 07:53 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 1st July 2025 - 02:10 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.