 Oil filler block off for Type IV bus case, the title should have it covered, I hope |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Seventyfive914 |
 Feb 8 2006, 05:37 PM
Post
#1
|
|
Member  Group: Members Posts: 72 Joined: 9-December 04 From: Wilmington, NC Member No.: 3,249  |
Hey All. Anyone have a line on a block off plate for a type IV bus motor to bag the lower oil filler neck attachment? Thanks for any assistance. Regards, -K-
|
   |
 
|
  |
Replies
| URY914 |
Feb 8 2006, 06:11 PM
Post
#2
|
|
I built the lightest 914 in the history of mankind. Group: Members Posts: 121,070 Joined: 3-February 03 From: Jacksonville, FL Member No.: 222 Region Association: None |
I made one out of 1/8" aluminum and I have one someone else made out of 1/4" steel plate.
Not a big deal. |
 |
|
Posts in this topic
Seventyfive914 Oil filler block off for Type IV bus case Feb 8 2006, 05:37 PM
Aaron Cox should just be a plate and a gasket right?
sounds... Feb 8 2006, 05:38 PM Seventyfive914 I have a length of 1/8 inch stock that I could cut... Feb 8 2006, 05:45 PM
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 8th June 2024 - 07:35 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.