Rust repair Questions, Welding, cutting, POR15ing, etc. |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
Rust repair Questions, Welding, cutting, POR15ing, etc. |
rjames |
Feb 18 2006, 05:56 PM
Post
#1
|
I'm made of metal Group: Members Posts: 3,954 Joined: 24-July 05 From: Shoreline, WA Member No.: 4,467 Region Association: Pacific Northwest |
Rust treating, killing, etc, and just want to get some input before I get to crazy with the MIG.
Here are some questions: I have some floor pan issues. Are the holes too big just to try and fill? The following photo is from the driverside, under the seat after the tar has been removed, and I've grinded down to bare metal. Should I advertise for someone who's cutting up a car to cut this pieces out for me, or should I just go buy some sheet metal and make a patch knowing it won't really match, but can at least be made to 'line up'? Attached image(s) |
rjames |
Feb 21 2006, 01:00 PM
Post
#2
|
I'm made of metal Group: Members Posts: 3,954 Joined: 24-July 05 From: Shoreline, WA Member No.: 4,467 Region Association: Pacific Northwest |
My guesses:
If there is rust still present, then that area is going to keep on rusting unless fully 'encapsulated'. Bare untreated metal will rust eventually as moisture gets to it (regardless of whether you are the one splashing the water on it) due to humidity in the air. |