 Spindle location? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| slugmika |
 Mar 5 2006, 02:08 PM
Post
#1
|
|
Member  Group: Members Posts: 208 Joined: 19-February 03 From: Finland Member No.: 318  |
Is spindle in a same line as the balljoint? i'am putting the front axle to right wheel base and was wondering if i could take the measure from baljoint?
Mika |
   |
 
|
  |
Replies
| slugmika |
Mar 6 2006, 09:54 AM
Post
#2
|
|
Member Group: Members Posts: 208 Joined: 19-February 03 From: Finland Member No.: 318 |
thanks Chris
I'll attach my front axle to chassis table today. What do you say about front axle? should i put height in a factory settings which is 9cm from torsion bar center to ball joint? I'am going to raise the spindle 25mm and was thinking about raising whole front suspension by 25mm. Mika |
|
|
|
Posts in this topic
slugmika Spindle location? Mar 5 2006, 02:08 PM
sixnotfour Due to castor angle ,the spindle is behind the bal... Mar 5 2006, 02:12 PM slugmika yes, factory castor is 6' but is the spinle in... Mar 6 2006, 04:53 AM Racer Chris The spindle is on the centerline of the strut tube... Mar 6 2006, 06:40 AM
Racer Chris 9cm is way too much. 3-4cm should be plenty. Rai... Mar 6 2006, 07:15 PM |
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 6th July 2025 - 07:23 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.