 SS Exhaust Flanges |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| srb7f |
 Mar 19 2006, 05:34 PM
Post
#1
|
|
Member  Group: Members Posts: 157 Joined: 17-May 04 From: Roswell, GA Member No.: 2,077 Region Association: None  |
Anybody know of a source for new exhaust flanges for a 1.8? Ideally, they would be stainless with a thickness of approximately 1/8" that could simply be welded to the existing flanges on the SS heat exchangers I have that don't seal up as well as they used to. Any help would be appreciated, Steve
|
   |
 
|
  |
Replies
| srb7f |
Mar 19 2006, 06:07 PM
Post
#2
|
|
Member Group: Members Posts: 157 Joined: 17-May 04 From: Roswell, GA Member No.: 2,077 Region Association: None |
It's not the material I'm particularly concerned about, but rather the fact that it's very difficult to get the exhaust to seal up properly due to corrosion, deformation, etc. on the heat exchanger flange. I guess I'm basically just looking to build a good sealing surface so that a regular gasket will do the job without leaking. Steve
|
|
|
|
Posts in this topic
srb7f SS Exhaust Flanges Mar 19 2006, 05:34 PM
SirAndy Mar 19 2006, 05:53 PM Racer Chris 1/8" won't be any good for sealing. You reall... Mar 19 2006, 06:14 PM srb7f 1/8" in addition to the existing 1/4" won't se... Mar 19 2006, 06:55 PM
Racer Chris Since I'm a professional I couldn't get aw... Mar 19 2006, 09:33 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 1st June 2024 - 09:13 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.