Tow Bar Bracket, From David Lee Options

[DanT]

Got my tow bar bracket a couple weeks ago from David Lee.
You can find the thread in the resources section about purchasing one.
They are very sturdy and bolt right into the existing reinforced mounting area for the front of the A arms/torsion bars.
A very nice piece of equipment right from one of our very own. (IMG:http://www.914world.com/bbs2/html/emoticons/biggrin.gif)
Doesn't take very long to install.

The following are a few pics I took during intallation.

The first pic is what you see when you first look under the front of your teener and begin the install. You will see the 2 normal 17mm bolts and inside the protector cup for the front of the torsion bar tube is an 8mm allen. Up inside the little slot on the front of the cup.

[DanT]

yes, the bracket is very strong. You could probably pick the car up by the bracket (IMG:http://www.914world.com/bbs2/html/emoticons/wink.gif)

Kind of doubt I will make it to the zone AX. Still pointing toward mid April with CDS at BW.
Did not start a separate thread today but I also got my torsion bars in today along with my Porterfield pads in the front. Next is the rear porterfields. rebleed the brakes and run oil lines. Also fabbed up my mounting hardware for the cooler in the front trunk, today. (IMG:http://www.914world.com/bbs2/html/emoticons/smile.gif)
Once all that is done I will get it back on the ground a rough out my ride hieght. I am pretty happy with the rear, I may go down one more indentation on the Bils on the rear. then set the front with about a 2 degree rake towards the front. And pray I still have enough shock travel. If not I will raise it up one notch on the rears and reset.
Then off for alignment and a few other items at the shop. (IMG:http://www.914world.com/bbs2/html/emoticons/biggrin.gif) (IMG:http://www.914world.com/bbs2/html/emoticons/wacko.gif)