 Step Studs, Stripped head |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| BMXerror |
 Oct 20 2006, 06:42 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,705 Joined: 8-April 06 From: Hesperia Ca Member No.: 5,842  |
Anyone ever stripped the threads out of the head with the exhaust studs. Well, the guy who owned my car before me put studs that were too short in and they didn't bite on enough thread. He tried to tighten them with not enough thread and stripped the head out. To the point, does anybody make T4 step studs? If not, has anyone else encountered this problem (doubt I'm the only one), and if so, how did you fix it. I went to four places looking for step studs today with no luck, so any help would be great. Thanks.
Mark D. |
   |
 
|
  |
Replies
| DNHunt |
Oct 20 2006, 07:46 PM
Post
#2
|
|
914 Wizard? No way. I got too much to learn. Group: Members Posts: 4,099 Joined: 21-April 03 From: Gig Harbor, WA Member No.: 598 |
I know there are 9mm X 8mm studs cause I've used them and I think there may be 10mm X 8mm but I haven't personally seen them. Not too tough a job.
Dave |
|
|
|
Posts in this topic
BMXerror Step Studs Oct 20 2006, 06:42 PM
brp914 I put in a helicoil, which has held up a couple ye... Oct 20 2006, 09:06 PM davep I'm having Len set me up for step studs on my ... Oct 20 2006, 09:14 PM So.Cal.914 Timesert's will take care of the problem very ... Oct 21 2006, 12:42 AM HeloMech VeeDub parts down here in HB has standard 8-8 stud... Oct 22 2006, 12:37 PM
jk76.914 earlier I recommended 8/9mm step studs on the othe... Oct 22 2006, 10:09 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 2nd June 2024 - 02:10 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.