Progress made on rust repair, Fit the easy panels |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
Progress made on rust repair, Fit the easy panels |
DNHunt |
Nov 5 2003, 08:47 PM
Post
#21
|
914 Wizard? No way. I got too much to learn. Group: Members Posts: 4,099 Joined: 21-April 03 From: Gig Harbor, WA Member No.: 598 |
Fit the panels to repair the inner wheel well. Feels good to be starting to put things back together. Still have more clean up and more pieces to make. Here's the surgery on the drivers side
Attached image(s) |
DNHunt |
Nov 12 2003, 11:25 AM
Post
#22
|
914 Wizard? No way. I got too much to learn. Group: Members Posts: 4,099 Joined: 21-April 03 From: Gig Harbor, WA Member No.: 598 |
I have the same flex shaft. Great tool but it takes time to do much with it.
Gonna cut a little more out of the top of the framerail. Just a small window so I can get access to the inside. Since i already have the top layer off I decided that the small amount of work needed would be more than made up for by having good access to inspect and treat the inside. Also, the nut under jack point that holds the rocker panel twisted off when I removed the stove bolt. I suspect red cancer. So, as long as I've come this far I better be sure and take care of it. Also I can weld on a new nut. Now that the inner wheel well is solid I'm not worried about the car bending Dave |
Lo-Fi Version | Time is now: 2nd June 2024 - 07:54 AM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |