 Front End Quiz, Ok Doc |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| r_towle |
 Feb 1 2007, 04:29 PM
Post
#1
|
|
Custom Member  Group: Members Posts: 24,705 Joined: 9-January 03 From: Taxachusetts Member No.: 124 Region Association: North East States 
 |
Here is the situation.
Wobble at highway speed. Felt in hand, in steering wheel. New tires, new rims (several times) Jack car up, No tie rod wobble at all (hands at 3 and 9 oclock, nothing) No ball joint wobble (tire in air, long bar underneath..nothing) New bearings. We currently have this car off the road for the winter...and we will remove the entire front end assembly this time. so, there is the question... Where is it??? Rich |
   |
 
|
  |
Replies
| r_towle |
Feb 1 2007, 04:54 PM
Post
#2
|
|
Custom Member Group: Members Posts: 24,705 Joined: 9-January 03 From: Taxachusetts Member No.: 124 Region Association: North East States
|
ok, the rubber I can figure out how to check...look, see if its broken...replace...
How do I check the rack? At this point I am hoping its maybe a bushing gone bad...just happens to get nasty on the highway... I do however feel a slight clunk in the wheel when I wiggle it side to side while standing still.... Its all coming out. I need to figure this out, its my kids car.... So, up she goes onto her perch...and of course, while we are in there...new everything... Side note. Andy, while its winter, and Im re-doing my suspension, on my car...I am going to figure out some sort of bearing support for the anti-sway bar (clunk on gas tank) issue. I have a good idea, just need to measure up, and I think I can get all the parts from McMaster Carr...should be straight forward, and hopefully a good solution. Rich |
|
|
|
Posts in this topic
r_towle Front End Quiz Feb 1 2007, 04:29 PM
SirAndy
Where is it???
i'm no Dr., but ...
have you... Feb 1 2007, 04:48 PM dr914@autoatlanta.com I always say that if one has front end shake, chec... Feb 1 2007, 05:02 PM
r_towle
I always say that if one has front end shake, che... Feb 1 2007, 05:06 PM dr914@autoatlanta.com
I always say that if one has front end shake, ch... Feb 1 2007, 05:09 PM Eric_Shea
:agree:
What year? There was an UpFix'n wr... Feb 1 2007, 05:08 PM PinetreePorsche Wheels 1-3: 1)-were the bare rims balanced befor... Feb 1 2007, 09:40 PM r_towle
:agree:
What year? There was an UpFix'n w... Feb 1 2007, 09:54 PM r_towle Ill add to this here, cause the quoting part was h... Feb 1 2007, 10:02 PM Dr. Roger when the wheels are on the car, and it's jacke... Feb 1 2007, 10:09 PM r_towle
when the wheels are on the car, and it's jack... Feb 1 2007, 10:15 PM ws91420 Inner tie rod ends? If haven't swicthed to tub... Feb 1 2007, 10:11 PM ws91420
Inner tie rod ends? If haven't swicthed to tu... Feb 1 2007, 10:37 PM rick 918-S You may have addressed this, I read through this f... Feb 1 2007, 10:17 PM r_towle
You may have addressed this, I read through this ... Feb 1 2007, 10:20 PM John Have you put a dal gauge on all four hubs and meas... Feb 1 2007, 10:42 PM Dave_Darling That's one of those things that has about six ... Feb 2 2007, 12:21 AM hellsbend I'd check that rack VERY closely, wear and dam... Feb 2 2007, 12:44 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 9th May 2025 - 11:49 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.