 Pertronix installation, magnetic cylinder |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| merrill |
 Mar 19 2007, 04:13 PM
Post
#1
|
|
Dirt Pimp  Group: Members Posts: 224 Joined: 25-January 05 From: Tahoe City, Ca Member No.: 3,505 Region Association: None  |
Does the magnetic cylinder need to fit the cam then be pressed down, then refit and press down again? I cannot get it down far enough for the rotor and cap to fit.
|
   |
 
|
  |
Replies
| Allan |
Mar 19 2007, 05:40 PM
Post
#2
|
|
Teenerless Weenie Group: Members Posts: 8,373 Joined: 5-July 04 From: Western Mesopotamia Member No.: 2,304 Region Association: Southern California |
I had the same problem when I installed mine. I ended up filing off a little of the bottom of the rotor and using a deep socket, tapped "LIGHTLY" on the magnet.
|
|
|
|
Posts in this topic
merrill Pertronix installation Mar 19 2007, 04:13 PM
shelby/914 Had the exact same problem so I just pulled the di... Mar 19 2007, 06:17 PM merrill Thanks for the feedback. I will hopefully have ti... Mar 20 2007, 01:32 PM
merrill Pertronix and new coil installed and car runs... Mar 21 2007, 05:07 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 11th May 2025 - 02:25 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.