 pesky oil leaks..., loose head bolts?? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| crash914 |
 Mar 19 2007, 07:18 PM
Post
#1
|
|
its a mystery to me  Group: Members Posts: 1,830 Joined: 17-March 03 From: Marriottsville, MD Member No.: 434 Region Association: MidAtlantic Region  |
ok, so I started to pull apart the motor to replace the base shims..
where is all this oil coming from? my head nuts were loose, I think the oil was coming from the head stud to the case? anyone else run across this?  it looks like my cylinder was leaking also...  |
   |
 
|
  |
Replies
| Pat Garvey |
Mar 19 2007, 08:09 PM
Post
#2
|
|
Do I or don't I...........? Group: Members Posts: 5,900 Joined: 24-March 06 From: SE PA, near Philly Member No.: 5,765 Region Association: North East States |
Did you torque the heads in the proper sequence?
I didn't & have cylinder head oil leak after 20 years ( minor, but major on a CW car). Took a shortcut - got burned. It DOES leak. It DOES make a mess. I AM stupid. I WILL fix it this spring. DUMB, DUMB, DUMB. Got expert advice. Didn't listen. Paying for it now. Anyone know if you can change this seal/gasket without removing the motor? Apologize for hijacking this thread. Pat |
|
|
|
Posts in this topic
crash914 pesky oil leaks... Mar 19 2007, 07:18 PM
crash914 ARP studs,
finger tight in case, I think I forgo... Mar 19 2007, 07:21 PM crash914 head shot... Mar 19 2007, 07:24 PM crash914 bump.... :bump: Mar 20 2007, 11:34 AM Matt Romanowski Herb, It can also be a leak somewhere about and ju... Mar 20 2007, 01:20 PM crash914 Matt, mine are flat, I also welded in a support to... Mar 20 2007, 04:34 PM McMark Welding can cause warping in the valve covers.
Pa... Mar 20 2007, 04:39 PM crash914 mark, motor is already out....
I did talk to Char... Mar 20 2007, 06:05 PM Brando 80cc per chamber doesn't sound right. Sure it... Mar 20 2007, 08:05 PM Aaron Cox you cc'd to the bottom of the head?
you only ... Mar 20 2007, 08:10 PM crash914 cylinders are coming off to replace base shims...
... Mar 21 2007, 05:20 AM
Headrage I don't know if I'm comparing apples to or... Mar 21 2007, 08:39 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 3rd July 2025 - 01:48 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.