 MIG welding gas, What do you use? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| obscurity |
 Apr 8 2007, 07:46 PM
Post
#1
|
|
Member  Group: Members Posts: 411 Joined: 24-February 06 From: Atlanta ,GA Member No.: 5,628 Region Association: South East States  |
I did a search but didn't find much. What gas are you using for your MIG welder? 100% CO2, CO2/argon, or 100% Argon?
Just Curious, John W. |
   |
 
|
  |
Replies
| PRS914-6 |
Apr 8 2007, 07:55 PM
Post
#2
|
|
Excellence Magazine Project 914 3.6 Group: Retired Members Posts: 1,278 Joined: 20-May 06 From: Central California Member No.: 6,031 Region Association: None  |
QUOTE(obscurity @ Apr 8 2007, 06:46 PM)  I did a search but didn't find much. What gas are you using for your MIG welder? 100% CO2, CO2/argon, or 100% Argon? Just Curious, John W. What I use.... Thick metals with more penetration (not as pretty) use straight CO2 Fabricating and thinner metals (better looking welds) use CO2/Argon mix YMMV |
|
|
|
Posts in this topic
obscurity MIG welding gas Apr 8 2007, 07:46 PM
skline You could either have Aaron come over and fart aro... Apr 8 2007, 07:49 PM JPB When all else fails or when in dought, us straight... Apr 8 2007, 07:50 PM Aaron Cox 50/50 fart / argon mix as skline mentioned :roll... Apr 8 2007, 07:58 PM LS6/914 Mild steel, 75% Argon / 25% CO2. Aluminum, 100% Ar... Apr 8 2007, 08:27 PM BigD9146gt FWIW, the gas mix Argon and CO2 reasoning is 75%/2... Apr 8 2007, 09:03 PM nebreitling if you're cheap, use straight CO2. it costs n... Apr 8 2007, 09:14 PM John
I did a search but didn't find much. What ga... Apr 8 2007, 09:22 PM Travis Neff 75/25 Argon/CO2 Mix Apr 8 2007, 09:37 PM Andyrew helistar I do believe its called.. but its 75/25.. Apr 8 2007, 09:59 PM Maltese Falcon 75/25 aka "Steel Mix"
marty Apr 8 2007, 10:33 PM bperry I use 100% CO2 but then I only weld steel and my w... Apr 8 2007, 10:50 PM
LvSteveH Good advice so far. A few other points of interest... Apr 9 2007, 02:02 AM |
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 9th June 2024 - 06:45 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.