 Head temp sensor replacement..., can do with engine in car? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| yarin |
 Apr 15 2007, 07:47 AM
Post
#1
|
|
'14-X'in FOOL  Group: Members Posts: 988 Joined: 13-May 03 From: Guttenberg, NJ Member No.: 693 Region Association: North East States  |
Can you replace the factory head temp sensor with the engine still in the car?
Thanks |
   |
 
|
  |
Replies
| ejm |
Apr 15 2007, 07:57 AM
Post
#2
|
|
I can see the light at the end of the tunnel Group: Members Posts: 2,712 Joined: 3-February 03 From: Massachusetts Member No.: 224 Region Association: None |
It can be done. There are special sockets made for this that have a slot for the wire. I use a deep six point socket that has the face ground flush so it grabs as much of the sensor as possible. To clear the wire use an extension that has one corner ground off. Thread the wire up thru the socket then put the extension in.
|
|
|
|
Posts in this topic
yarin Head temp sensor replacement... Apr 15 2007, 07:47 AM
vsg914 Yes. 13mm very deep socket. grind one corner off a... Apr 15 2007, 07:57 AM
Bleyseng
Yes. 13mm very deep socket. grind one corner off ... Apr 15 2007, 10:17 AM yarin I assume I have to remove that side of the engine ... Apr 15 2007, 08:18 AM BMartin914
I assume I have to remove that side of the engine... Apr 15 2007, 08:23 AM yarin Ok.. I didn't realize there was an access hole... Apr 15 2007, 08:36 AM BMartin914 You don't even have to remove the intake runne... Apr 15 2007, 08:50 AM rmital Most IMPORTANT....put just a couple drops of super... Apr 15 2007, 09:59 AM Tobra so I am guessing you have one copper washer in the... Apr 15 2007, 10:02 AM rmital
so I am guessing you have one copper washer in th... Apr 15 2007, 10:11 AM pbanders
so I am guessing you have one copper washer in t... Apr 16 2007, 06:10 PM NoEcm This works too (circa 1981 or 1982): Apr 16 2007, 01:10 AM Jeffs9146 Be careful not to cross thread the sensor threads.... Apr 16 2007, 05:41 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 18th December 2025 - 05:26 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.