 Valve Train Assembly Question |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| vesnyder |
 Oct 4 2007, 06:57 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 680 Joined: 14-April 05 From: Cleveland, OH Member No.: 3,933  |
I am reassembling the valve train on my 2.0 (with my new Len Hoffman heads) and I am not sure how the ends of the rockers should go in? They are beveled - do the bevels face toward the head or away? How about the space on the same end - does ths face up or down? Thanks!
|
   |
 
|
  |
Replies
| vesnyder |
Oct 4 2007, 08:18 PM
Post
#2
|
|
Senior Member Group: Members Posts: 680 Joined: 14-April 05 From: Cleveland, OH Member No.: 3,933 |
Found a set that had not been cleaned yet and I could see that the beveled edge faces away from the head -washer mark.
|
|
|
|
Posts in this topic
vesnyder Valve Train Assembly Question Oct 4 2007, 06:57 PM
SLITS Not sure what you mean by bevels, but the split in... Oct 4 2007, 07:31 PM davep I believe the beveled edges should face out. Oct 4 2007, 07:53 PM thomasotten I thought the bevels went to the head side, and I ... Oct 4 2007, 07:56 PM
thomasotten Oh, I see now. My comments were made thinking yo... Oct 4 2007, 08:30 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 1st June 2024 - 07:17 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.