 Wiring for oil temp?, Where does the wire that goes to the taco plage come from? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Joe Owensby |
 Jan 7 2008, 08:32 PM
Post
#1
|
|
JoeO  Group: Members Posts: 527 Joined: 7-January 06 From: Spartanburg, SC Member No.: 5,385 Region Association: South East States  |
As title said, I need to hook up my oil temp gauge after about 2 years on stands. I can't find the wire that goes to the taco plate temp sensor. It may have broken off the harness. I re-covered the portion of the harness from the exit of the firewall upward. Did I maybe cover up the temp wire, or does it come from somewhere else?
Thanks, JoeO |
   |
 
|
  |
Replies
| So.Cal.914 |
Jan 8 2008, 12:43 AM
Post
#2
|
|
"...And it has a front trunk too." Group: Members Posts: 6,588 Joined: 15-February 04 From: Low Desert, CA./ Hills of N.J. Member No.: 1,658 Region Association: None |
It's one wire, run it thru the tunnel along the loom and to your console, hook it to
the gauge. I did it on my 71 and my 72, no big deal. |
|
|
|
Posts in this topic
Joe Owensby Wiring for oil temp? Jan 7 2008, 08:32 PM
Spoke The oil temp gauge wire goes from the taco plate t... Jan 7 2008, 09:40 PM
SirAndy
The oil temp gauge wire goes from the taco plate ... Jan 7 2008, 10:55 PM Spoke
The oil temp gauge wire goes from the taco plate... Jan 8 2008, 01:43 PM SirAndy
Well at least I'm hitting 100%.
Hmm. I guess... Jan 8 2008, 05:03 PM SirAndy
As title said, I need to hook up my oil temp gau... Jan 7 2008, 10:54 PM orange914
early cars didn't have the wire in the harne... Jan 9 2008, 09:19 PM type47 i agree w/Andy if you car is a later car but add t... Jan 8 2008, 08:30 AM Cevan Here is my post on this topic. My wire was green ... Jan 8 2008, 02:28 PM Joe Owensby Thanks everyone. I will check the wires below the... Jan 8 2008, 07:34 PM Spoke Here is the schematic from my 70-72 Shop Manual by... Jan 8 2008, 11:05 PM SirAndy
It shows item 42 to be "Oil Temperature Indi... Jan 9 2008, 01:05 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 1st June 2024 - 03:41 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.