 Caliper removal, Need pics or detailed instruction |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| stateofidleness |
 Aug 8 2010, 02:17 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 810 Joined: 1-September 07 From: Canyon Lake, Texas! Member No.: 8,065 Region Association: None  |
The pelican article assumes a lot. One picture and vague directions such as "remove both bolts", with no mention of their location, size, etc.
I've never messed with the brakes before so I don't know what all I'm looking at. Since the hardline nut is a perfect circle now (wow...) i had to cut it in half, now I'm trying to remove the caliper from the car (rear drivers) and don't know the order or which bolts to loosen. I have taken the parking brake cable off, and removed the 90angle little clips, but not sure where to go from there... can someone post some pics of the bolts the hold the halves together and maybe their size? any other trips/tricks/pitfalls to avoid will be greatly appreciated as well! brake bleeding job has turned into a "replace every 40yr old part of the brake system" job... sigh. had to go buy some flare wrenches too, never heard of them before this! |
   |
 
|
Posts in this topic
stateofidleness Caliper removal Aug 8 2010, 02:17 PM
swl it is really pretty simple. The two bolts are big... Aug 8 2010, 02:30 PM tradisrad hopefully you have gotten the calipers off of the ... Aug 8 2010, 03:06 PM stateofidleness what are these "adjusters" i keep readin... Aug 8 2010, 03:09 PM type47 If the middle part you refer to is the pads, sprin... Aug 8 2010, 03:14 PM Spoke For the rear calipers, there is an adjusting nut o... Aug 8 2010, 03:21 PM stateofidleness k, just got the 19mm bolts out, got the caliper of... Aug 8 2010, 04:02 PM tod914 51 pounds of torque on the bolts that hold the cal... Aug 8 2010, 04:07 PM stateofidleness lol.. soooo.. got it all buttoned up, begin bleedi... Aug 8 2010, 06:14 PM type47 I'd have to admit in front of the whold world ... Aug 9 2010, 06:28 AM
Spoke
I'd have to admit in front of the whold world... Aug 9 2010, 10:23 AM '73-914kid Um.. I can get my 19mm 3/4 inch drive spanner back... Aug 9 2010, 09:38 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 2nd July 2025 - 07:33 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.