 Before and After, Brintech in Stanton - WOOHOO! |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| avidfanjpl |
 Sep 17 2010, 01:38 AM
Post
#1
|
|
914 Hemophiliac  Group: Members Posts: 720 Joined: 6-April 10 From: Bear, Delaware Member No.: 11,566 Region Association: MidAtlantic Region  |
Greg Brinton was recommended to me for the work. Here is before and after on a car that had only jackpoint rust. And only around the squares and tubes, but I cut it all out, and he wheeled the rest out that you see in the before pics. Talk about great welding! TIG he said. I don't know the freakin difference, but this car was buttoned up tonight and 16 months of work is done!
I have other pics but the list is official Changed out. Mostly by me Brakes Oil cooler jackposts - Brintech valances and rockers - new rockers old valances all powdercoated - EMBEE FI harness Injector gaskets All Fuel Hoses, air and gas filters, gaskets Polished rails, painted injector pipes Full underbody cleaning Gas tank refurbish - Me and Cooper Boggs Pump Vacuum hoses Polished all aluminum inside and out Tires Fog lights Lights Complete Markers Front turn signals all bulbs all fuses and relays Axles and CV's All heater underside parts powdercoating All tuning and lash, timing/dwell Still to go full set of bilsteins full set of elephant bushings lemforder ball joints springs? Underbody strip and reseal Engine detailing front/rear trunk detailing Then I get my 1987 Carrera Coupe on 30 Nov from my bud in CT. That one is clean and mostly done. White with Grey - He is doing the finishing Woohoo! Only took 16 months and an undisclosed sum! AX on Saturday. Hope I don't break anything. John     |
   |
 
|
Posts in this topic
avidfanjpl Before and After Sep 17 2010, 01:38 AM
jaxdream That looks great :Qarl: !! Did the repair... Sep 17 2010, 06:42 AM
avidfanjpl Yes
He had to reach up with a very small welding ... Sep 17 2010, 10:16 AM Tom_T John - I may need him if some of my welding is too... Sep 17 2010, 10:43 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 3rd June 2024 - 07:49 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.