 Type-4 engine question, Can bores be swapped? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| stewteral |
 Sep 19 2010, 11:23 PM
Post
#1
|
|
Old Member  Group: Members Posts: 384 Joined: 4-December 07 From: Camarillo, CA Member No.: 8,424 Region Association: Southern California  |
Hey 914ers,
I have a basic "dumb" question: I have a 1.7 engine and am looking at a rebuild. Will the 1.8 liter bores fit into my cases or will machining be required? Are there any other issues involved such as bore height, fitting the heads, fitting the case studs, etc.? Thanks, Terry |
   |
 
|
Posts in this topic
stewteral Type-4 engine question Sep 19 2010, 11:23 PM
Mark Henry Fits the case, but the heads would need to be open... Sep 19 2010, 11:28 PM McMark :agree: Sep 19 2010, 11:34 PM rhcb914 If you looking for more displacement I would go wi... Sep 20 2010, 08:18 AM
stewteral
If you looking for more displacement I would go w... Sep 20 2010, 06:55 PM Mark Henry
If you looking for more displacement I would go ... Sep 20 2010, 07:02 PM 914Sixer No machining of the case for 96mm. Heads only. Sep 20 2010, 07:01 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 3rd June 2024 - 05:49 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.