Engine rebuild, a few questions Options

[stugray]

I have rebuilt a type IV a couple of times, but I was young & naive.
This will be a 2.0L with stock FI for vintage racing.

1 - How do I hook up the stock fuel pump line(s) to a fuel cell?

2 - are there any Cams other than the stock one that will give me increased performance while still using the stock FI?

3 - What compression ratio should I target? I am working that step right now - CC'ing the heads & setting the deck height.

4 - The CAM thrust bearing has just one side with the thrust plate on it. If I recall, when I upgraded my last 914, the guy at the performance shop gave me TWO with the thrust bearing on it (one for each side). Should I be looking for those?

5 - After splitting the case, there were 2 or 3 "bumps" that needed a little "flattening out" with a file. Can the case be damaged by trying to clean up the nasty spots, or is there a way for me to make sure to get it right?

I imagine that the only thing I could do would be to remove all the studs and rub each side over some sandpaper taped down to a very flat surface...

Any help is appreciated.

Stu