 1.7 idle, i dove into the car |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| smrz914 |
 Jul 13 2004, 12:12 PM
Post
#1
|
|
Soon to be brightening the life of the person behind you.  Group: Members Posts: 456 Joined: 21-April 03 From: Pleasant Hill, CA or Chico, CA Member No.: 596  |
So i talked to the PO and he said that there was a wire that needed to be connected before the car would idle correctly. The pic shows what I found. The green arrow is of two wires that are not connected to anything and the red arrow is of where i think they should go. But I have no idea what the red arrow part is. The red arrow part seems to be broken at the "wire connector".
Attached image(s) 
|
   |
 
|
Posts in this topic
smrz914 1.7 idle Jul 13 2004, 12:12 PM
ArtechnikA every time i speculate about a DJet car i wind up ... Jul 13 2004, 12:38 PM smrz914 The PO loaned the car to a friend and the car woul... Jul 13 2004, 12:50 PM lapuwali Low idle can be lots of things, but I'd check ... Jul 13 2004, 01:20 PM brant The cold start injector (If the full FI had everyt... Jul 13 2004, 01:24 PM Joe Ricard can't se it from this side of the engine pictu... Jul 13 2004, 01:42 PM smrz914 Ok well i'll ignore the wires and set the timi... Jul 13 2004, 01:43 PM wheelo Throttle Positioning Sensor - should check and cal... Jul 13 2004, 10:12 PM
Bleyseng Make sure the vacuum retard hose is hooked to the ... Jul 13 2004, 10:49 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 28th May 2024 - 11:33 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.