 Oil cooler seal replacement, Impossibe with engine installed |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Ctrout |
 Aug 6 2004, 07:41 PM
Post
#1
|
|
Member  Group: Members Posts: 377 Joined: 20-May 04 From: Mountain Home, ID. Member No.: 2,091  |
Has anybody here tried to replace your oil cooler seals with the engine installed in the vehicle (a la pelican article)? The article is a little vague and I think I loosened the wrong bolt and now I may have to drop the engine just to tighten it again! (IMG:style_emoticons/default/headbang.gif) I loosened a 17mm bolt next to the oil filter and now it just spins. I think there is a nut behind it that I can't get to. Does anybody have a picture indicating the correct bolts (or nuts) to remove?
|
   |
 
|
Posts in this topic
Ctrout Oil cooler seal replacement Aug 6 2004, 07:41 PM
tommy914 You need to loosen these to get the oil cooler sea... Aug 6 2004, 07:56 PM Brad Roberts This is great.. I laugh my ASS OFF when people wal... Aug 6 2004, 08:02 PM McMark I know you can get the oil cooler side tin off in ... Aug 6 2004, 08:07 PM Brad Roberts Double nut the oil cooler studs and pull them out ... Aug 6 2004, 08:10 PM Demick Hey - I wrote that tech article (many moons ago). ... Aug 6 2004, 08:26 PM Ctrout Here is the bolt that I loosened. Is there a way ... Aug 6 2004, 08:30 PM Demick If you loosened it, you should be able to tighten ... Aug 6 2004, 08:53 PM Ctrout From referencing Tommy's photo above, I was ab... Aug 6 2004, 09:00 PM thomasotten Besides your problem with that bolt, I know that t... Aug 6 2004, 09:35 PM Mike9142.0 That is a case thru bolt (holds the case halfs tog... Aug 6 2004, 10:29 PM Ctrout Can it be reached while the engine is in the car? ... Aug 6 2004, 11:26 PM Mike9142.0 You will need to take the lower tin off the left s... Aug 6 2004, 11:31 PM michelko Hi everybody,
while my spare engine hanging in the... Aug 7 2004, 02:11 AM tod914 Didn't realise George had tech articles on his... Aug 7 2004, 07:25 PM
SpecialK Had to go out to the garage and see exactly where ... Aug 8 2004, 12:25 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 8th June 2024 - 01:05 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.