 OK, now what?, Outer rear brake adjusting screw |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Part Pricer |
 Aug 25 2004, 06:36 PM
Post
#1
|
|
Believe everything I post  Group: Benefactors Posts: 1,825 Joined: 28-December 02 From: Danbury, CT Member No.: 35   |
The outer rear brake adjusting screw is stripped. I can stick my 4MM hex key in there and it just spins like a chick on acid at a Dead concert.
Any suggestions on getting this thing to turn? Should I just cut a slot across it and turn it with a flathead? Any BTDT would be greatly appreciated. |
   |
 
|
Posts in this topic
Part Pricer OK, now what? Aug 25 2004, 06:36 PM
Racer Chris It's been a few years now since I dealt with a... Aug 26 2004, 05:47 AM anthony Are you talking about the inboard or the outboard ... Aug 26 2004, 08:42 AM Cap'n Krusty Aluminum? Would that be the special "ferrous" alu... Aug 26 2004, 11:29 AM fiid Nope. The inside cover is aluminium (stock) and s... Aug 26 2004, 12:57 PM anthony Cap, you must be having an off day. The factory in... Aug 26 2004, 01:06 PM rj777 just finished this job, before you cut anything tr... Aug 26 2004, 01:11 PM fiid Hmmm.... you said outside adjustment screw. Teach... Aug 26 2004, 01:13 PM fiid RJ777 is right - there is a lock nut. Make sure t... Aug 26 2004, 01:14 PM anthony I was the one who mentioned the inside cap because... Aug 26 2004, 01:44 PM Mark Henry The down and dirty method to get off the cap screw... Aug 26 2004, 01:46 PM
Demick Do what Fiid suggests. Use a Torx and tap it in. ... Aug 26 2004, 01:46 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 3rd June 2024 - 05:47 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.