Rear Control Arm Pivot Shaft Failure, Almost got the shaft... |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
Rear Control Arm Pivot Shaft Failure, Almost got the shaft... |
bulitt |
Feb 9 2012, 03:11 PM
Post
#1
|
Achtzylinder Group: Members Posts: 4,188 Joined: 2-October 11 Member No.: 13,632 Region Association: South East States |
So, pulled my control arms to change out the rubber bushings and they looked fine from the outside and the pivot shaft surface looked fine so for a moment I almost left them alone.
The procedure as documented by Eric in the classic section looked easy enough and since I had already purchased the bushings I decided to change them out. Both shafts had heavy rust on the outside ends. Looks like the bushings were wore, allowing water to penetrate between the shaft and bushing. Approx 120 degrees of one shaft was eaten away to the point I could stick a screwdriver into the shaft. This would have failed sometime in the future. |
Lo-Fi Version | Time is now: 8th June 2024 - 12:12 AM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |