 Popping and Lean on Decel- Dual Weber IDF's |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| tornik550 |
 Jul 15 2012, 07:20 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,248 Joined: 29-January 07 From: Ohio Member No.: 7,486 Region Association: None  |
I have been trying to dial in my carbs (dual weber 44 idf's). I recently made a jet change (and no other changes). Now I am going lean and popping on decel. I did not have this issue before the jet change which makes my doubt an exhaust leak. My air fuel gauge reads 14.5 at idle, 11 on accel and 17 on decel. The changes that I made were decreased the air corrector jet to 200 (from 210) and increased the main jet from 145 to 150.
Since it is so freaking hot out I want to be prepared before going outside. The engine is running fine. Head temps were around 290-300 after hard acceleration. Ideas? |
   |
 
|
Posts in this topic
tornik550 Popping and Lean on Decel- Dual Weber IDF's Jul 15 2012, 07:20 PM
mrbubblehead
I have been trying to dial in my carbs (dual webe... Jul 15 2012, 08:46 PM
tornik550
I have been trying to dial in my carbs (dual web... Jul 15 2012, 08:55 PM KaptKaos With MrBubbleHead's (Doug's) help, my 40id... Jul 15 2012, 08:58 PM tornik550
With MrBubbleHead's (Doug's) help, my 40i... Jul 15 2012, 08:59 PM KaptKaos
With MrBubbleHead's (Doug's) help, my 40... Jul 15 2012, 09:09 PM mrbubblehead drop down to 800 rpm hot. then reset your MIXTURE ... Jul 15 2012, 09:08 PM tornik550
drop down to 800 rpm hot. then reset your MIXTURE... Jul 15 2012, 09:16 PM mrbubblehead
drop down to 800 rpm hot. then reset your MIXTUR... Jul 15 2012, 10:06 PM KaptKaos I believe that I had a similar issue. I was tuni... Jul 15 2012, 09:36 PM mrbubblehead 27 degrees is fine for now. you may find that your... Jul 15 2012, 10:10 PM rhodyguy it sounds like you're real close. leave everyt... Jul 16 2012, 08:44 AM mrbubblehead its been my experience that if you try and cut cor... Jul 16 2012, 09:09 AM rhodyguy do you mean what i suggested is half assed corner ... Jul 16 2012, 09:15 AM mrbubblehead
do you mean what i suggested is half assed corner... Jul 16 2012, 09:21 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 3rd June 2024 - 07:43 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.