 Can Anyone Cut A Custom Gauge Panel?, A few holes in a piece of wood |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| 7TPorsh |
 Dec 12 2012, 12:42 PM
Post
#1
|
|
7T Porsh  Group: Members Posts: 2,691 Joined: 27-March 06 From: Glendale Ca Member No.: 5,782 Region Association: Southern California 
 |
I am re-locating my console gauges up into the dash. I bought a nice piece of grained cherry wood that I want to use; it's about 1/4" thick, 6" wide and about 40" long.I have enough wood for maybe 3 or 4 of these if anyone else interested.
If I send you the rectangular cut wood, does anyone here have the means for cutting out the gauge holes? Basically 5 holes to hold 4 52mm gauges and a 60mm clock in a rectangular shaped piece. Will look like this:  oh crap...Admin, please move to garage forum. thx |
   |
 
|
Posts in this topic
7TPorsh Can Anyone Cut A Custom Gauge Panel? Dec 12 2012, 12:42 PM
Vacca Rabite For the 52mm gauges you can use a 2 1/8 inch hole ... Dec 12 2012, 02:38 PM gms You could just get hole saws for this and it would... Dec 12 2012, 02:40 PM 7TPorsh I guess I could just use a "big bit" hol... Dec 12 2012, 03:54 PM ellisor3 62mm hole saw
http://www.amazon.com/MK-Morse-MK385... Dec 12 2012, 04:54 PM The Cabinetmaker I just happen to know a guy who can do that for yo... Dec 12 2012, 05:10 PM 7TPorsh don't the rubber rings hold them in place? Dec 12 2012, 05:14 PM
Vacca Rabite
don't the rubber rings hold them in place?
m... Dec 12 2012, 06:27 PM Vacca Rabite If you get an adjustable hole cutter you can cut a... Dec 12 2012, 06:26 PM zig-n-zag I would cut that on a router table free hand.
Hol... Dec 13 2012, 01:43 PM 7TPorsh well I gave it a shot. ^$%#*&^^$ it
... Jan 2 2013, 01:07 PM r_towle Try this, it works.
Take your hole saw and drill ... Jan 2 2013, 03:30 PM 7TPorsh
I just happen to know a guy who can do that for y... Jan 2 2013, 05:48 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 20th May 2024 - 02:39 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.