 Bent trailing arm, how to tell? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| blitZ |
 Feb 23 2013, 10:43 AM
Post
#1
|
|
Beer please...  Group: Members Posts: 2,223 Joined: 31-August 05 From: Lawrenceville, GA Member No.: 4,719 Region Association: South East States  |
I hit a 4x4 in the road a few years ago, hard enough to bend my wheels. Since then I've had more negative camber on the drivers side. I think my trailing arm is bent. Is there anyway to measure? I'm in the process of going 5 lug, so think I might just replace it.
|
   |
 
|
Posts in this topic
blitZ Bent trailing arm Feb 23 2013, 10:43 AM
Racer Chris Its really hard to measure on the vehicle, althoug... Feb 23 2013, 11:38 AM Joe Sharp :agree: Yeah what Chris said. I think it would be ... Feb 23 2013, 12:07 PM
Racer Chris
I think it would be really hard to bend the trai... Feb 23 2013, 01:00 PM kg6dxn
I think it would be really hard to bend the tra... Feb 23 2013, 07:00 PM 914Sixer Porsche had a jig that you put them in to test. T... Feb 23 2013, 02:00 PM blitZ I have both arms off as I am replacing the bushing... Feb 23 2013, 02:18 PM Dave_Darling There's a picture with measurements in the Hay... Feb 23 2013, 08:41 PM Racer Chris
There's a picture with measurements in the Ha... Feb 24 2013, 06:56 AM Sneezy You can put two 3' rods through the 2 holes. T... Feb 23 2013, 10:17 PM SirAndy I have seen a factory drawing of the 914 rear trai... Feb 24 2013, 02:22 PM Racer Chris 12.5 deg toe, -1.5 deg camber. Feb 24 2013, 09:54 PM blitZ I've sourced a couple of good arms, just to be... Feb 25 2013, 06:33 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 1st June 2024 - 04:34 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.