 Front control arm Bushings, Removal help |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| malcolm2 |
 Mar 3 2013, 03:58 PM
Post
#1
|
|
Advanced Member  Group: Members Posts: 2,747 Joined: 31-May 11 From: Nashville Member No.: 13,139 Region Association: South East States 
 |
I am sure I have mentioned before that searching on this forum just does not work very well for me. So if I can get some help, I will be grateful.
I have dropped my suspension today. 20 months and I have finally made it to tearing down the front of this car. Anyway, how in the world do you get the bushings and holders off? I did some research a while back, but only remember bits and pieces. Did I read that I can HEAT the hell out of them and basically melt the out? Do they have to be pressed out? Again, any instructions or re-direction to a previous post will the awesome. Clark  |
   |
 
|
Posts in this topic
malcolm2 Front control arm Bushings Mar 3 2013, 03:58 PM
Harpo I used a whole lot of heat to get mine out.
David Mar 3 2013, 04:00 PM 914Sixer Chain one end to a vise or nearest tree. Grab a c... Mar 3 2013, 04:04 PM kg6dxn BTW, you do not have to start a new thread for eve... Mar 3 2013, 04:26 PM
malcolm2
BTW, you do not have to start a new thread for ev... Mar 3 2013, 05:59 PM t collins This link should help you
http://www.elephantrac... Mar 3 2013, 04:46 PM malcolm2
This link should help you
http://www.elephantra... Mar 3 2013, 06:15 PM t collins
[quote name='t collins' post='1829001' date='Mar ... Mar 3 2013, 06:50 PM malcolm2
This link should help you
http://www.elephantra... Mar 3 2013, 08:58 PM Jeffs9146 Just clamp the arm in a vice, heat the bracket wit... Mar 3 2013, 04:50 PM mrbubblehead i tried the torch screw driver method and mine wou... Mar 3 2013, 05:10 PM Tedman5 I did the screw and twist method with no heat. Onl... Mar 3 2013, 05:21 PM mr914 Drilled out what I could w 1/8" bit. Broke ou... Mar 3 2013, 05:57 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 7th June 2024 - 08:41 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.