 914/6 fan belt, Deflection |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| bcheney |
 Jun 2 2013, 04:36 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,341 Joined: 16-November 03 From: Orlando, FL Member No.: 1,348 Region Association: South East States  |
Since you cannot see the belt welll enough to measure deflection after reinstalling what is the best way to be sure you have the tension correct? I installed my alternator today...left one shim between the pulley halfs and 5 on the outside. I tightened everything down and fired her up. The voltmeter shows just over 14 volts now. I turned it off and tightened the nut a bit more and made sure the belt was seated properly. The belt feels a bit loose...I can twist it between my fingers a half turn. Do you think I am good to go or should I move all shims to the outside and see if that seems to feel better?
|
   |
 
|
Posts in this topic
bcheney 914/6 fan belt Jun 2 2013, 04:36 PM
pcar916 I always make sure I can push the belt in about 1/... Jun 2 2013, 04:47 PM 6freak
Since you cannot see the belt welll enough to mea... Jun 2 2013, 05:44 PM
larryM if too loose, it will make a slapping noise at hig... Jun 2 2013, 10:41 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 6th June 2024 - 08:30 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.