Home  |  Forums  |  914 Info  |  Blogs
 
914World.com - The fastest growing online 914 community!
 
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG. This site is not affiliated with Porsche in any way.
Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners.
 

Welcome Guest ( Log In | Register )

> fuel system question
last337
post Jun 7 2013, 06:38 PM
Post #1


Member
**

Group: Members
Posts: 421
Joined: 4-December 12
From: New Orleans
Member No.: 15,221
Region Association: None



I have been having a lot of problems with my fuel system. I can't tellif it is the fuel pump or just something in the gas tank. I pulled the outlet hose of the fuel pump to try to pump the remaining gas out of the gas tank.however when I did the fuel pump barely put out a trickle of gas. I disconnected the inlet side of the fuel filter in front of the fuel pump and no remaining guess came out from the fuel tank side. I know there was still some gas in the tank but I was assuming that the pressure had locked it up to where no more gas would come out.what I am wondering now is if its the fuel pump is bad or if its something clogging the outlet of the fuel tank. I did put my finger over the end of the fuel pump outlet and only felt a small amount of pressure it was not pushing my finger off by any means. Is it possible that there is a clog on the outlet side of the tank? WhenI start up the engine it runs for a couple minutes and then when it comes under load it dies. If I let it sit for a few minutes the fuel filter then fills back up with gas and then it will run again for another few minutes. Does anybody have any suggestions of where I should go next.
User is offlineProfile CardPM
Go to the top of the page
+Quote Post

Posts in this topic
last337   fuel system question   Jun 7 2013, 06:38 PM
Cap'n Krusty   Remove the vapor recovery tank on the top of the f...   Jun 7 2013, 07:07 PM
last337   I have never been inside the fuel tank. Is it easy...   Jun 7 2013, 08:26 PM
--axel--   I have never been inside the fuel tank. Is it eas...   Jun 7 2013, 08:30 PM
--axel--   I have never been inside the fuel tank. Is it ea...   Jun 7 2013, 08:33 PM
Mblizzard   Search for a thread called fuel sock. I don't...   Jun 7 2013, 08:32 PM
last337   How do I go about unclogging the tank without remo...   Jun 8 2013, 07:20 AM
rick 918-S   How do I go about unclogging the tank without rem...   Jun 8 2013, 08:14 AM
rhodyguy   where is the pump installed? the strainer/sock wil...   Jun 8 2013, 07:59 AM
rhodyguy   rick, what's in the tank when you electrify it...   Jun 8 2013, 09:00 AM
last337   Well after pulling the tank I realized it was a hu...   Jun 8 2013, 05:53 PM
turk22   That's a great job! :beer2: I see this...   Jun 8 2013, 09:39 PM
last337   I can't seem to locate a replacement sock filt...   Jun 9 2013, 07:44 PM
jbachert   I can't seem to locate a replacement sock fil...   Jun 9 2013, 07:52 PM
last337   Thanks! I found the screen on the Tangerine s...   Jun 10 2013, 07:55 AM
--axel--   Thanks! I found the screen on the Tangerine ...   Jun 10 2013, 08:28 AM
--axel--   Thanks! I found the screen on the Tangerine...   Jun 10 2013, 08:30 AM
last337   Which pieces did you replace? I am a bit confused...   Jun 10 2013, 08:32 AM
--axel--   Which pieces did you replace? I am a bit confuse...   Jun 10 2013, 08:37 AM
rhodyguy   not that difficult a task to switch the tunnel lin...   Jun 10 2013, 08:31 AM
last337   not that difficult a task to switch the tunnel li...   Jun 10 2013, 08:37 AM
rhodyguy   new lines...front. tank outlet fitting to ss in tu...   Jun 10 2013, 08:43 AM
last337   new lines...front. tank outlet fitting to ss in t...   Jun 10 2013, 09:57 AM
last337   How do I know which line I need? 8mm or 9.5mm? D...   Jun 10 2013, 10:15 AM
last337   I spoke with Chris at Tangerine and I think I got ...   Jun 10 2013, 10:49 AM
rhodyguy   get rid of the facet pump. k   Jun 10 2013, 11:05 AM
last337   get rid of the facet pump. k Should I go with ...   Jun 10 2013, 12:48 PM
--axel--   get rid of the facet pump. k Should I go with...   Jun 10 2013, 01:57 PM
last337   Well after pulling the tank and cleaning all that ...   Jul 7 2013, 11:40 AM
The Cabinetmaker   gas is transfered from the refining process to a h...   Jul 7 2013, 12:09 PM
last337   Well there were huge chunks of stuff coming out. I...   Jul 7 2013, 01:08 PM
The Cabinetmaker   Probably not. Gas turns to a jellied vanish substa...   Jul 7 2013, 02:32 PM


Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



- Lo-Fi Version Time is now: 4th June 2024 - 03:41 PM