 901 gearbox advice, end float on Drive Shaft |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| VEEMAN |
 Jun 15 2013, 06:02 AM
Post
#1
|
|
Newbie  Group: Members Posts: 7 Joined: 15-June 13 From: United Kingdom Member No.: 16,015 Region Association: None  |
I'm currently rebuilding a 901 gearbox. I've fitted a new roller bearing onto the Drive shaft. On tightening the nut on the shaft to as far as it would tighten ( torque unknown, correct torque would be appreciated ). I noticed that I had a 9 thou gap between the 5th gear cog and the thrust washer ( see attached photo)
I have another 901 box and it also has similar play on the shaft at this point. I'm not sure if this gear box has been striped in the past. So my question if any one can help. Is this play got to be there? Also if the shaft has to be tightened further, how do you lock the shaft to get the desired torque. Any thoughts would be welcome. Thanks. Veeman  |
   |
 
|
Posts in this topic
VEEMAN 901 gearbox advice Jun 15 2013, 06:02 AM
rgalla9146
I'm currently rebuilding a 901 gearbox. I... Jun 15 2013, 07:57 AM VEEMAN Thanks for the quick reply. I've shone some li... Jun 15 2013, 09:17 AM
pcar916 Howdy Veeman and welcome,
The factory documentatio... Jun 15 2013, 09:20 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 9th May 2025 - 09:13 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.