 initial Valve train try |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| jmargush |
 Jun 22 2013, 06:21 PM
Post
#1
|
|
Member  Group: Members Posts: 460 Joined: 8-June 04 From: Goshen, IN Member No.: 2,176  |
I ran the first try for my valve train geometry and I need some input or votes of confidence!
9590 Cam from Raby Waiting on my adjustable push rod tool and shim kit (in case I need it). So I just put in the stock push rod and cycled the intake valve. Spec lift is to be .426 and I got .4365 which is within the 5% rule. So I cycled it back to half way open and here is what the adjuster to valve looks like. is this good or do I need to play with push rod length? Any input is appreciated. Attached thumbnail(s)  
|
   |
 
|
Posts in this topic
jmargush initial Valve train try Jun 22 2013, 06:21 PM
pilothyer As far as I can tell, by looking at the picture, t... Jun 23 2013, 12:54 PM malcolm2 Raby's directions worked for me. measure 2 or... Jun 23 2013, 01:10 PM stugray looks pretty good.
The hardest part in the instru... Jun 23 2013, 02:05 PM jmargush I am definitely going to use the chrome molly push... Jun 23 2013, 07:53 PM jmargush How did you guys go about cutting your pushrods?
... Jun 24 2013, 08:03 AM
malcolm2
How did you guys go about cutting your pushrods?
... Jun 26 2013, 09:36 AM stugray If I remember correctly, I clamped the pushrod in ... Jun 26 2013, 10:05 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 1st June 2024 - 08:00 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.