 Final (I hope) engine wire questions |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| lsintampa |
 Jul 2 2013, 10:28 AM
Post
#1
|
|
Senior Member  Group: Members Posts: 520 Joined: 28-January 13 From: Tampa, FL Member No.: 15,441 Region Association: South East States  |
75 914/4 2.0
Coming off of the FI wire harness is a branch (near the dizzy area) with a red, white, green/red, and black wire. 1) The red and black are marked by PO as going to the coil. I assume red to the positive side, and black to the negative side. But I want to make sure so that's more a question. 2) I'm not sure where the green/red wire goes. There is a temp sensor (or some sensor) that is top side near the dizzy. I think that green/red goes there? 3) Almost sure that the white goes to the AAR. Finally there is a bundle of white wires coming off near the transmission. They all have large eye connectors and I assume them to be ground wires - even though they are white. I attached them to one of the tranny / motor mount bolts. |
   |
 
|
Posts in this topic
lsintampa Final (I hope) engine wire questions Jul 2 2013, 10:28 AM
gunny You are correct with all of the white wires as gro... Jul 2 2013, 10:37 AM malcolm2 Resources are everywhere.... try this one:
bowls... Jul 2 2013, 10:50 AM lsintampa Took a picture.
I've looked at the wire diag ... Jul 2 2013, 11:59 AM
ThePaintedMan
So here's a picture of what I'm talking ... Jul 2 2013, 12:22 PM Jeff Bowlsby That is the ignition harness, not the FI harness. ... Jul 2 2013, 12:22 PM lsintampa
That is the ignition harness, not the FI harness.... Jul 2 2013, 01:33 PM Tom I am with Jeff here. Verify where the wires go on ... Jul 2 2013, 12:49 PM lsintampa OK, traced them back to the 12 point connector on ... Jul 2 2013, 01:09 PM lsintampa Well the green/red and white were correct.
I have... Jul 2 2013, 01:14 PM Tom Pin #1 is for the oil pressure sender, normally gr... Jul 2 2013, 02:41 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 28th May 2024 - 06:20 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.