 CB performance rotary pump with 40 IDFs, Use the fuel pressure regulator or not? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| AE354803 |
 Aug 10 2013, 03:26 PM
Post
#1
|
|
Member  Group: Members Posts: 232 Joined: 13-August 12 From: Southern California Member No.: 14,801 Region Association: Southern California  |
When installing the CB performance rotary fuel pump, do you normally leave the flying saucer looking fuel pressure regulator in line after it or remove it?
Everything I've seen in the weber book says 2.5 psi, but the CBperformance pump is 3.5 psi. Then again people say this is the pump to use and it seemed like they meant without the FPR. Thanks!! Andy http://www.cbperformance.com/ProductDetail...roductCode=3193 |
   |
 
|
Posts in this topic
AE354803 CB performance rotary pump with 40 IDFs Aug 10 2013, 03:26 PM
SLITS Supposedly at 5 psig, you will overide the needle ... Aug 10 2013, 03:29 PM Elliot Cannon I've been using a CB Performance pump for 10 y... Aug 10 2013, 03:56 PM
fitzm1 I have a 2.0 with 40 idf carbs and no regulator. N... Aug 10 2013, 06:15 PM DBCooper It's internally regulated so you don't nee... Aug 10 2013, 06:20 PM DBCooper Oops, doppelpost Aug 10 2013, 06:20 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 3rd June 2024 - 02:54 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.