 6 Cyl oil tank, line questions |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| tornik550 |
 Dec 11 2014, 09:19 AM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,248 Joined: 29-January 07 From: Ohio Member No.: 7,486 Region Association: None  |
I am converting to a 6 cyl. I have a 2.2e case. I purchased a PMS tank. I have been able to figure out the normal routing for the oil lines however I already had an oil cooler in the front of my car from my previous engine. I was using a Mocal Sandwich plate. Here are my questions-
1. I plan on using non-stock oil lines- what size should I use? I already have 10an for my front oil cooler- is 10AN adequate. 2. Is there a way that I can use my Mocal sandwich plate? If not- which type of thermostat should I get? At what level should it open (I think my current is 180 degrees)? 3. Where does the line from the vent hose on the oil filler neck connect? Does it connect to the vent on the center/top of the case? |
   |
 
|
Posts in this topic
tornik550 6 Cyl oil tank, line questions Dec 11 2014, 09:19 AM
brant You need an12 on a -6.
Including the front cooler Dec 11 2014, 09:22 AM
tornik550
You need an12 on a -6.
Including the front coole... Dec 11 2014, 09:32 AM Mark Henry You need a mocal thermostat.
-10 might work for a... Dec 11 2014, 09:41 AM SLITS
I can't remember, I think the one on the tank... Dec 11 2014, 09:54 AM tornik550
You need a mocal thermostat.
-10 might work for ... Dec 11 2014, 10:03 AM Mark Henry Does the RX7 cooler still have it's thermostat... Dec 11 2014, 10:50 AM tornik550
Does the RX7 cooler still have it's thermosta... Dec 11 2014, 10:57 AM Mark Henry
Does the RX7 cooler still have it's thermost... Dec 11 2014, 11:40 AM tornik550
[quote name='tornik550' post='2121161' date='Dec ... Dec 11 2014, 11:55 AM Mark Henry
[quote name='Mark Henry' post='2121172' date='Dec... Dec 11 2014, 12:05 PM Dave_Darling The 911 race car guys like to run lines that are a... Dec 11 2014, 12:21 PM patssle -12AN is fine but running -16AN from tank to engin... Dec 11 2014, 01:44 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 29th May 2024 - 12:53 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.