 Installation of Passenger side Rear Suspension, Measurements |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| ndfrigi |
 Feb 3 2015, 11:26 AM
Post
#1
|
|
Advanced Member  Group: Members Posts: 2,967 Joined: 21-August 11 From: Orange County Member No.: 13,474 Region Association: Southern California 
 |
Hi dear teeners!
I'm about to install my rear suspension console (from restoration design) replacement with the help of Mark doing the welding. Anyone used restoration design console and is it just bolt on the same spot? I was not able to get any measurement since the old console is damaged. I tried the measurement of 28 1/4" from center firewall to the console. I'm getting that measurement but it is on the accelerator cable tube from firewall to the driver side console center hole for the rear arm. Is that right? accelerator cable tube looks like it is not the center of the firewall. Please help! Thanks again!   |
   |
 
|
Posts in this topic
ndfrigi Installation of Passenger side Rear Suspension Feb 3 2015, 11:26 AM
ndfrigi RE: Installation of Passenger side Rear Suspension Feb 3 2015, 11:29 AM
Han Solo The guys that do this procedure regularly have a j... Feb 3 2015, 12:17 PM ndfrigi
The guys that do this procedure regularly have a ... Feb 3 2015, 12:22 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 16th July 2025 - 03:50 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.