 More problems, Exhaust blowing at head |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| DavidSweden |
 Jun 7 2015, 10:17 AM
Post
#1
|
|
Member  Group: Members Posts: 479 Joined: 8-June 14 From: Sweden Member No.: 17,452 Region Association: Scandinavia  |
Will the problems never stop....... well what would I do anyway if I wasn't constantly assembling and disassembling the engine?
I retrofitted 74 heat exchangers on my 76 2.0 Californian car. The exhaust is blowing pretty bad at the manifold gaskets, the stud nut are good and tight. Can anyone give me some advice on the best solution to this problem. Thanks again |
   |
 
|
Posts in this topic
DavidSweden More problems Jun 7 2015, 10:17 AM
stugray The first trick is to check the flatness of each p... Jun 7 2015, 10:24 AM brant Each time the exchangers come off you should annea... Jun 7 2015, 10:24 AM
DavidSweden
Each time the exchangers come off you should anne... Jun 7 2015, 10:37 AM Mike Bellis
Each time the exchangers come off you should ann... Jun 7 2015, 10:39 AM 76-914 I like to glue a sheet of 120 grit to a flat piece... Jun 7 2015, 11:56 AM BeatNavy I went through this a couple of months ago. They ... Jun 7 2015, 11:58 AM DavidSweden Thanks for the help guys it is much appreciated. :... Jun 7 2015, 01:07 PM Racer Chris
...
I found the hardest part during the actual in... Jun 8 2015, 07:34 AM Elliot Cannon Wasn't there a discussion not too long ago abo... Jun 7 2015, 04:45 PM McMark Also, tighten the nuts a little at a time, moving ... Jun 8 2015, 08:51 AM Elliot Cannon
Also, tighten the nuts a little at a time, moving... Jun 8 2015, 10:40 AM Mike Bellis Really easy to do. I use this technique on my turb... Jun 8 2015, 03:15 PM Spoke I had the same problem after an install. Turns out... Jun 8 2015, 03:55 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 28th May 2024 - 06:24 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.