 side shift console - Is this OK to use? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| mikedsilva |
 Jul 6 2015, 04:36 AM
Post
#1
|
|
Member  Group: Members Posts: 90 Joined: 23-February 15 From: Australia Member No.: 18,462 Region Association: Australia and New Zealand  |
I bought some parts from Brad Mayeur to convert my tailshift to sideshift...
I have the engine and trans out and when I went to clean up the parts, I noticed that the area of the side shift console is a bit "corroded" just outside of the o ring area. So, for those that are familiar with these components, can i simply change the o-ring and install, or should I take it to a machine shop for careful milling? My little soda blaster was not able to shift any of the raised areas.... (IMG:http://www.914world.com/bbs2/uploads_offsite/i1260.photobucket.com-18462-1436179000.1.jpg) (IMG:http://www.914world.com/bbs2/uploads_offsite/i1260.photobucket.com-18462-1436179001.2.jpg) |
   |
 
|
Posts in this topic
mikedsilva side shift console - Is this OK to use? Jul 6 2015, 04:36 AM
Tbrown4x4 I would attempt a gasket scraper and wire brush. E... Jul 6 2015, 05:46 AM
914ltd The corrosion is not on a sealing surface, dress a... Jul 6 2015, 06:39 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 1st June 2024 - 09:46 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.