 Push Rod Guide Wire...is it a must have on engine?, Push Rod Guide Wire in Engine |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| 0396 |
 Nov 6 2015, 05:53 PM
Post
#1
|
|
Advanced Member  Group: Members Posts: 2,046 Joined: 13-October 03 From: L.A. Calif Member No.: 1,245 Region Association: Southern California  |
Need to tap into the brain trust.
I was just looking at a YouTube video on a type 4 engine assembly. I noticed that person attached a wire to the valve assembly. I looked at the F/S section and noticed that there's set for sale. Question, is that a monitory to install guide the push rods? Thanks for the education. |
   |
 
|
Posts in this topic
396 Push Rod Guide Wire...is it a must have on engine? Nov 6 2015, 05:53 PM
dlee6204 It's a retaining feature for the pushrod tubes... Nov 6 2015, 06:02 PM
396
It's a retaining feature for the pushrod tube... Nov 6 2015, 07:00 PM Dave_Darling They mentioned as above, but in the 25 years of b... Nov 6 2015, 08:00 PM porschetub
They mentioned as above, but in the 25 years of ... Nov 7 2015, 12:54 AM brant
It's a retaining feature for the pushrod tub... Nov 6 2015, 11:32 PM The Cabinetmaker They are a must. The tube will back out and make a... Nov 6 2015, 06:15 PM Mblizzard I have seen them back out! If you think about... Nov 6 2015, 07:16 PM r_towle They will back out.
I have seen set screws run up ... Nov 6 2015, 07:29 PM Elliot Cannon Wire? Use this stuff. High temp silly cone. :lo... Nov 6 2015, 08:00 PM Dave_Darling
Wire? Use this stuff. High temp silly cone. :l... Nov 6 2015, 10:05 PM ConeDodger My last TypeIV build I bought them new at the P de... Nov 6 2015, 08:02 PM porschetub
My last TypeIV build I bought them new at the P d... Nov 7 2015, 01:01 AM 396 To all, thanks for the education. Looks like its ... Nov 6 2015, 11:08 PM 396 To all, thanks for the education. Looks like its ... Nov 6 2015, 11:09 PM rhodyguy Tight confines with that barbed fitting and the in... Nov 7 2015, 08:47 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 28th May 2024 - 06:09 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.