 Show me your cradle |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| cwpeden |
 Jan 24 2016, 05:40 PM
Post
#1
|
|
Great White North, huh?  Group: Members Posts: 916 Joined: 20-August 06 From: Victoria BC Member No.: 6,693 Region Association: Canada  |
In my vanilla 73 2.0 I'm at the top of the autocross field in my area, Porsche wise.
Now I need to beat the Miata's. I'm going to start with a EJ251 I just picked up. Asking everyone who has done or help with a conversion. What would you do differently with respect to supporting the engine and trans? Is a full cradle required or is supporting from the front and rear preferred? What wasn't strong enough? What has or hasn't failed? Too stiff? Too flexible? What was in the way? I'm going to use stock rear points what about the front? Thanks for any suggestions. |
   |
 
|
Posts in this topic
cwpeden Show me your cradle Jan 24 2016, 05:40 PM
r_towle You cannot support it from the front, the engine m... Jan 24 2016, 05:48 PM
cwpeden
You cannot support it from the front, the engine ... Jan 24 2016, 06:17 PM
tazz9924
You cannot support it from the front, the engine ... Jan 24 2016, 06:37 PM veekry9 Something wrong with your 914?
Miatas should be ea... Jan 24 2016, 05:56 PM cwpeden
Something wrong with your 914?
Miatas should be e... Jan 24 2016, 06:18 PM r_towle The two side bars go to a cross member that uses t... Jan 24 2016, 06:20 PM effutuo101 Not sure if Ian is make these any more. Also Reneg... Jan 24 2016, 06:52 PM Mike Bellis Mine was built to fit any motor. The bolt on engin... Jan 24 2016, 07:51 PM aircooledtechguy
Mine was built to fit any motor. The bolt on engi... Jan 24 2016, 09:28 PM DBCooper This the Smallcar mount, to put a Subaru engine in... Jan 24 2016, 08:13 PM mgp4591 Mike, I know your tube cradle is made from fairly ... Jan 24 2016, 08:17 PM Mike Bellis
Mike, I know your tube cradle is made from fairly... Jan 24 2016, 08:21 PM veekry9
Mine was built to fit any motor. The bolt on engi... Jan 24 2016, 08:23 PM Mike Bellis
Mine was built to fit any motor. The bolt on eng... Jan 24 2016, 08:26 PM 76-914 Here's mine. A variant of DB cooper's that... Jan 24 2016, 09:06 PM DBCooper
Here's mine. A variant of DB cooper's tha... Jan 25 2016, 10:58 PM cwpeden What is the prefered arrangment with regards to mo... Jan 25 2016, 02:41 PM Mike Bellis
What is the prefered arrangment with regards to m... Jan 25 2016, 10:34 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 7th June 2024 - 09:03 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.