 Center hard brake lines |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Amphicar770 |
 Feb 24 2016, 09:06 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,197 Joined: 20-April 10 From: PA, USA Member No.: 11,639 Region Association: MidAtlantic Region 
 |
This "while the engine is out" project seems to have no end.
I was going to replace all the brake lines from proportioning valve back. Now I am thinking that it may make sense to do the lines that run through the center tunnel. At the same time, with costs adding up is it overkill. I see several threads on the fuel lines but none in the center brake lines. Is that because it is super easy (just pull the through rear or front). Or is it that it is either a real pia or something rarely needed? Finally, I do have an NOS proportioning valve but it is the late style without the "T". If I ordered late style rear lines would it be an easy switch or did various mounting tabs, holes on car body also change. Thanks yet again. |
   |
 
|
Posts in this topic
Amphicar770 Center hard brake lines Feb 24 2016, 09:06 PM
pdlightning
This "while the engine is out" project ... Feb 24 2016, 10:26 PM Amphicar770
I always thought the brake lines were the same ... Feb 25 2016, 12:03 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 8th June 2024 - 12:36 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.