 CV Joints, Curil K |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| srreality |
 May 21 2016, 11:18 AM
Post
#1
|
|
Member  Group: Members Posts: 73 Joined: 14-July 15 From: Colorado Member No.: 18,957 Region Association: None  |
Beginner's dumb question #56: The Porsche factory manual says to "Glue plate spring with specified grease to joint, with hollow end facing the joint. If the cap has been removed from the joint, seal again with compound Curil K"
2 questions: Is there an equivalent to Curil K available at any auto parts store? Where does the "glue" go on the plate spring/spring retainer to joint go? I bought new CV boots with cap already attached, so I assume sealant goes around joint itself before slipping it into the boot/cap, wiping off the excess? Thanks, |
   |
 
|
Posts in this topic
srreality CV Joints May 21 2016, 11:18 AM
914Sixer NO glue needed. Just put them on and use them. Co... May 21 2016, 12:24 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 2nd June 2024 - 04:55 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.